Difference between revisions of "Installation and Integration/ActionItems"
Jump to navigation
Jump to search
JimStewart (talk | contribs) |
|||
Line 40: | Line 40: | ||
Detector installation. | Detector installation. | ||
− | I added info on the areal lift on the installation page. | + | I added info on the areal lift on the installation page. [http://www.palazzani.it/public/TZX%20550%20(170)_USA100346.pdf link] |
*'''-> Where is the info?''' | *'''-> Where is the info?''' |
Revision as of 12:33, 27 October 2016
Action Items for the Installation and Integration group
1. Cryostat design
TCO interface
- List of the components using the TCO
- -> Where is the info?
- -> Who?
- TCO dimensions
- Space inside needed to close the TCO
Roof penetration locations
- Detector support structure interference
- -> Jack
- Instrumentation feedthrus
- HV feed thru
- Detector readout feed thru
Cable routing to the feedthroughs
There are two options for reading out the lower APA. Either the cables are routed up through the upper APA or along the floor and up the wall. The floor option changes the number and location of the feedthrus. There are also grounding implications.
- -> Where is the info?
- -> Who?
Floor loading
The floor loading will probably be defined by the areal lift needed to reach the roof. A draft of the installation proceed needs revised and then the equipment at each step listed.
Main Steps are:
Installation of the detector support structure Installation of cryogenic piping, Detector installation.
I added info on the areal lift on the installation page. link
- -> Where is the info?
- -> Who?
2. Underground space
Plan for the work flow
- -> Where is the info?
- -> Who?
Ross Cage Design
Bill's proposal: docdb entry
- -> Bill
Random information and questions
- If we make the cage tall enough to fit the APA crate inside, the excavation equipment for CF may not fit inside because the cage reduces maximum width by ~4” (100 mm) as compared to a slung load
- Making the cage taller also makes it heavier, reducing the weight capacity for both slung and cage loads
- Can we do to the Yates shaft for some items? Boundary conditions.